SEARCH: OK

 

Subwoofers

 

 

  FULL INSTALLER SPECIFICATIONS

SS-250, 250 mm (10") Subwoofer Driver

The intention of the SS-250 was to create a relatively affordable subwoofer that would still out-perform the average 10 or even 12 inch subwoofer out in the market. The result was a "Best Buy" subwoofer in the car audio industry. A heavy duty cast aluminum frame with cavity vents, a 2" two layer heavy copper voice coil, a 1098 g (38.7 oz) magnet, and 24 K gold plated terminals are just some of the parts that go into this "entry level" subwoofer. It has a 400 W peak and are offered in either 4 or 8 ohms. Four 4 ohm subs can be bridged to 1 ohm to achieve a low frequency of just 16 Hz! As well, three 8 ohm subs bridged to 2 ohm will allow for the sub to be used in a 0.4 cubic foot sealed enclosure. The suggested operating range for this sub alone is 32 to 550 Hz.
 

 

 

 

  FULL INSTALLER SPECIFICATIONS

SS-300, 300 mm (12") Subwoofer Driver

The SS-300 is essentially the same as the SS-250, except for its size which yields bigger power output, and lower frequencies. However, it will require larger enclosure sizes, and it will not be able to be bridged to be used in a 0.4 cubic foot sealed enclosure. The suggested operating range for this sub alone is 28 to 550 Hz.
 

 

 

 

  FULL INSTALLER SPECIFICATIONS

EL-250, 250 mm (10") Subwoofer Driver

The AVI EL Series are hand built in our own facility in Canada, using the finest components in the world, and designed with high fidelity as the primary criterion. It is a fortunate coincidence that designing subwoofers for musical accuracy also makes them capable of stunning output levels.

EL Series subwoofers are optimized for small vented enclosures, and may also be successfully applied in 6th order bandpass enclosures or with aperiodic membranes. Alternative enclosures are also possible, and AVI dealers can provide information on enclosure design and construction.

The EL series is a less expensive version of the SL series. It is still a very good sounding subwoofer, with a 60 oz magnet, 24 K gold plated terminals, cast aluminum frame, and a 2" voice coil. It is also for use in a ported enclosure. The suggested operating range for the EL-250 is 33 to 600 Hz, and 26 to 500 Hz for the EL-300.
 

 

 

 

  FULL INSTALLER SPECIFICATIONS

EL-300, 300 mm (12") Subwoofer Driver

The AVI EL Series are hand built in our own facility in Canada, using the finest components in the world, and designed with high fidelity as the primary criterion. It is a fortunate coincidence that designing subwoofers for musical accuracy also makes them capable of stunning output levels.

EL Series subwoofers are optimized for small vented enclosures, and may also be successfully applied in 6th order bandpass enclosures or with aperiodic membranes. Alternative enclosures are also possible, and AVI dealers can provide information on enclosure design and construction.

The EL series is a less expensive version of the SL series. It is still a very good sounding subwoofer, with a 60 oz magnet, 24 K gold plated terminals, cast aluminum frame, and a 2" voice coil. It is also for use in a ported enclosure. The suggested operating range for the EL-250 is 33 to 600 Hz, and 26 to 500 Hz for the EL-300.

 

 


 

 FULL INSTALLER SPECIFICATIONS

SL-170, 170 mm (6.5") Subwoofer Driver

The SL Series subwoofers have been a very strong line since the beginning of AVI. It has gone through over 5 generations of modifications in the past 10 years. Today, this line is just as popular as when it was first sold, because they are still the most powerful and highest sound quality subs on the market. However, their intended use is strictly for ported enclosures or bandpass boxes.
 

 

 

 

  FULL INSTALLER SPECIFICATIONS

SL-250, 250 mm (10") Subwoofer Driver

The SL Series subwoofers have been a very strong line since the beginning of AVI. It has gone through over 5 generations of modifications in the past 10 years. Today, this line is just as popular as when it was first sold, because they are still the most powerful and highest sound quality subs on the market. However, their intended use is strictly for ported enclosures or bandpass boxes.

 

 

 



  FULL INSTALLER SPECIFICATIONS

SL-300, 300 mm (12") Subwoofer Driver

The SL Series subwoofers have been a very strong line since the beginning of AVI. It has gone through over 5 generations of modifications in the past 10 years. Today, this line is just as popular as when it was first sold, because they are still the most powerful and highest sound quality subs on the market. However, their intended use is strictly for ported enclosures or bandpass boxes.

 

 

 



 

FULL INSTALLER SPECIFICATIONS

 

SL-500, 250 mm (10") Subwoofer Driver

To achieve well extended, satisfying low bass from very small enclosures has long been a challenge for car audio manufacturers. AVI's radical new SL-500 meets the challenge, with a major departure from conventional thinking.


Mounting depth has been substantially reduced by positioning two magnets within the chassis, instead of one on the back. Dual voice coils allow maximum flexibility and are wound on a composite polyamide former for high power handling and output. The cone material is deeply convoluted to increase its tortional rigidity, and the SL-500 front suspension is the first in the world to use anechoic rubber material, to provide improved definition.

This is a dual voice coil subwoofer driver with an extremely shallow mounting depth of just 92 mm (3.6"). It may be connected in parallel (2 ohms), series (8 ohms) or at 4 ohms each from two amplifier channels (not recommended). The suggested operating range is 45 to 430 Hz.

For "stealth" installations, the remarkably small enclosure required for the SL-500 dramatically increases the number of practical mounting locations in any vehicle.

 

 

 

 

  FULL INSTALLER SPECIFICATIONS

SLS-200, 200 mm (8") Subwoofer Driver


It took AVI many years to develop a subwoofer for sealed and vented enclosures. The SLS-200 can be used in a small sealed box of just 0.4 cubic foot. Recommended for ported enclosures or bandpass boxes. The SLS-200 can also be used for sealed and even free air applications.

 

 

 


  FULL INSTALLER SPECIFICATIONS

SLS-250, 250 mm (10") Subwoofer Driver

It took AVI many years to develop a subwoofer for sealed and vented enclosures. The SLS-250 can be used in a small sealed box of just 0.4 cubic foot. The most noticeable physical feature is the magnets (which are approximately 100 oz together) used to power the subwoofer. Hidden within, is a massive 65 mm (2.6") voice coil. The suggested operating range for this sub alone is 28 to 550 Hz.

 

 

 



FULL INSTALLER SPECIFICATIONS

SLS-300, 300 mm (12") Subwoofer Driver

If you are obsessed with extremely low bass, then the SLS-300 would be the subwoofer of choice. It is recommended for very low bass in a sealed box enclosure. The most noticeable physical feature is the magnets (which are approximately 100 oz together) used to power the subwoofer. Hidden within, is a massive 65 mm (2.6") voice coil. The suggested operating range is 27 to 550 Hz.
 


 


 

FULL INSTALLER SPECIFICATIONS

GS-300, 300 mm (12") Subwoofer Driver

This model is similar the SL-300, but it has a different frame, cone, and rubber edge. The GS-300 can achieve lower bass than the SL300.
 

 

 

 

 FULL INSTALLER SPECIFICATIONS

GX-300, 300 mm (12") Subwoofer Driver

The GX-300 should actually be named: Monster 300! It is a 12" subwoofer with massive double magnets stacked to a total of 130 oz. Inside, a 3" voice coil and a double damper is what makes this subwoofer a powerhouse. It is designed for having huge amounts of power thrown at it, which makes it very popular in SPL competitions. It will handle over 1000 W RMS!

 

 

4728 Lankershim Blvd Lankershim Blvd, North Hollywood, CA. 91602
Telephone: 818.506.5300
Fax: 818.508.8055

© 2007 ADDI Inc. All rights reserved